Programming For Dvd Player; Searching For Component Codes; Using A Cabie Or Satellite Remote - Vizio SV420XVT User Manual

Hide thumbs Also See for SV420XVT:
Table of Contents

Advertisement

VlZlOSV420XVT1A U serManual
4176
Proqramminq
OVO
P<aver
1. Manually turn on the DVD Player.
2. Press the DVD button on the remote control.
3. Press and hold the SET button until the LED LIGHT flashes twice.
4. Find the programming code for your DVD player in the code list in the back of this book and enter it
using the Number Buttons.
If the code is accepted, the LED flashes twice after the last digit is
entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next code listed for the component
and manufacturer.
5. Point the remote control at the DVD Player and press the POWER button.
The DVD Player will turn
off.
q,.17,
7 Searchinq
for
Component
Codes
If you cannot find the manufacturer in the component list or the program code does not work, you can use
the remote control to search for the correct component code.
To search for a component code:
1.
Turn on the component.
2.
Press the matching component button on the remote control.
3.
Press and hold the SET button until the LED flashes twice.
4.
Press 9 9 1. The LED flashes twice.
5.
Point the remote control at the component and then alternate between pressing the POWER
button and the component
button on the remote control until the component
turns off.
If the component still does not respond, clear the component button, then repeat the search
procedure.
4°18
Usinq
a Cable
or
Satelloite
Remote
Your VIZlO remote uses codes 000, 047, 050, 067, 329, 331 and 339 to work your LCD HDTV. To use a
cable or satellite remote to work the LCD HDTV, refer to your cable or satellite remote user guide for
more information on how to program the remote.
If your cable or satellite remote uses a 5-digit code (like
most Direct TV units), first try 11758 and then, if that does not work, 10178.
If your cable or satellite
remote uses a 4-digit code, try 1758 and then 0178 as an alternative.
If your cable or satellite remote
uses a 3-digit code (Echostar or Dish Network for example), use code 627.
_,_ote: Some )utto_s
may _0t functon
as expected on yo r <able or sateite
remote
Typcay
r_c,_,_eL
vo
meandmutew!wok
Version 6/2/2008
76
www,VlZlO.com

Advertisement

Table of Contents
loading

Table of Contents