Advertisement
a
'
1, MEMORY
selector
This switch is used to select memory channels "
through '"5"*. The operating frequency can be stored in or
called back from the channel selected by this switch. In
channel
"'5', two different frequencies (transmit and
receive) can be stored for "odd-split"" reps
2. M switch
This is used to input desired frequencies to each channel
for memory. By pressing (am) the switch, the frequency
indicated on the display is stored in the selected channel,
3. MR switch
This is used to recall memory frequencies from each
channel.
4. Frequency display
LEDs display the operating frequency in 4 digits
(MHz — 1 kHz)
5. BUSY indicator
This lamp will light when the squelch is open in receive
mode.
6. ON AIR indicator
A light emitting diode (L.E.0.) will fight in the wansmit
mode.
8
'
oe
7. RPT indicator
When the TX OFFSET switch is set to + or ~ position, this
indicator lights.
8. S/RF-meter
This meter indicat
transmit output (RF).
receive input signal strength (S) or
9. TX OFFSET switch
Shifts the transmit frequency for repeater operation
—: Switches the wansmit frequency down 600 kHz
from the receive frequency.
S: Simplex (receive and transmit frequencies are the
same.)
+: Switches the transmit frequency up 600 kHz from
the receive frequency,
10. M.S (MEMORY SCAN) switch
Press this switch and the memory channels 1 ~ 5 are scan-
'ned. The scan operation stops at a channel where signal is
present. This switch should be used in conjunction with the
SQUELCH control (see page 11)
11. MIC connector (6-pin)
For connection of the supplied microphone.
Advertisement
