Operation - Panasonic EY6406 Instruction Manual

Variable speed cordless drill & driver
Hide thumbs Also See for EY6406:
Table of Contents

Advertisement

ASSEMBLY
Attaching or removing bit
Note: When attaching or removing a bit,
be sure to set the reversing lever to
its center position (switch lock).
This tool is equipped with a keyless drill
chuck.
1. Attachment
Insert the bit and turn the lock collar clock¬
wise (looking from the front) to tighten.
2. Removal
Turn the lock collar counterclockwise
(looking from the front), then remove
the bit.
3. Storage
Keep the bit in bit holder when not in
use.
Remove the battery pack to expose the
bit stora^ compartment inside the han¬
dle housing.
A bit up to 50 mm (1-31/32 inch) long
can be stored here.
50mm
Note: If excessive play occurs in the chuck,
® secure the drill in place and tighten
the chuck by turning ® clockwise, d)
open the chuck claws by unscrewing
the lock collar and d) tighten the screw
(left- handed screw) with a screwdriver
by turning it counterclockwise (viewed
from the front).
(D
Attaching or removing battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to Indicate proper connection.
2. To remove the battery pack:
Press the two tabs on the sides of the
battery pack. Slide the battery pack
out of the tool body.
OPERATION
Switch Operation
1. Depress the trigger switch slightly to
start the tool slowly.
2. The speed increases with the amount of
depression of the trigger for efficient
tightening of screws and drilling. The
brake operates and the chuck stops
immedately when the trigger is released.
Reversing Switch Operation
(Forward (O). Switch lock, Reverse (O))
CAUTION: Do not operate reversing lever
until the chuck comes to a com¬
plete stop. Shifting during rota¬
tion of the chuck may damage
the tool.
1. For reverse rotation, set the lever to
reverse. Check the direction of rotation
before use.
2. After use, set the lever to its center
position
Speed Selection
Choose a low or high speed to suit the use.
The more the speed control trigger is
pulled, the higher the speed.
CAUTION: Check the speed selector switch
before use.
(switch lock).
-
7
-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ey6407Ey6431

Table of Contents