Danfoss 088U0200 Instructions Manual page 9

Instruction CF-MC Master Controller
5.10 Transmission Test (Link Test)
Note: The transmission test (link test) between the Master Controller and other
system components, is initiated from the other system components like Room
Thermostats, Repeater Unit, Remote Controller, etc.
Please see the enclosed instruction for these components for transmission test
(link test) procedures.
Room Thermostats:
When the transmission test (link test) from a Room Thermostat is received
by the Master Controller, the assigned output(s) will fl ash. This makes it pos-
sible to identify the outputs to which a Room Thermostat has been assigned
(Fig. 23 - )
6. Confi guration
6.1 Actuator Outputs
Activate Output mode on Master Controller (fi g. 23)
• Use the menu selection button
fl ashes
• Activate Output mode by pressing OK . Output LED
Select the output confi guration
• Press the output selection button
put confi gurations
• 1 LED: The outputs are confi gured to NC actuators with ON/OFF regulation
(default)
• 2 LEDs: The outputs are confi gured to NO actuators with ON/OFF regula-
tion
• 3 LEDs: The outputs are confi gured to NC actuators with Pulse Width
Modulation (PWM) regulation for fl oor heating
• 4 LEDs: The outputs are confi gured to NO actuators with Pulse Width
Modulation (PWM) regulation for fl oor heating
• 5 LEDs: A Remote Controller is installed, and it is not possible to change
settings from the Master Controller
• Activate selected output confi guration by pressing OK
Note: During periods with no output activations the Master Controller will run a
valve motion program every 2 weeks and it will last for up to 12
minutes. Individual output confi guration is possible with Remote Controller,
CF-RC, see separate instruction.
VI.UH.K2.80
8
to select the Output mode. Output LED
and toggle between the possible out-
- the output LEDs will be ON – indicated below:
Produced by Danfoss Floor Heating Hydronics 01.2006
goes ON