Related Manuals for Comfee CFU20R1AWW
Summary of Contents for Comfee CFU20R1AWW
- Page 1 Reverse Osmosis Water Filtra on System Rated voltage: 100-125V AC Rated frequency: 50/60Hz Model Numbers: CFU20R1AWW Version A-0 12-2021...
- Page 3 Indicates a situation which, when not avoided, has the potential to WARNING result in death or severe injury; Indicates a situation which, when not avoided, results or has the CAUTION potential to result in minor injury; Indicates a situation which, when not avoided, results in death or DANGER severe injury.
- Page 4 Place the water puri er on a solid level surface. At low temperature, it is necessary to drain water to avoid damage caused by ice. Do not place the water purifier close to highly corrosive environment. A 100-125V, 50/60 Hz, AC only, 15 A or 20 A fused, grounded electrical supply is required.
- Page 5 Do not use outdoors. Keep the water puri er in a dry place and away from direct sunlight. Unplug the power cord by pulling straight out. Do not pull on the cord. For household use only. This appliance is intended to be used in a household and similar applications.
- Page 6 Do not connect hot water supply inlet to the water puri er, hot water will damage the RO membrane. RO Water should be used regularly, if stored longer than 3 days, drain the RO tank and ush the system with fresh water. If water is leaking from the water puri er, immediately unplug the power cord and turn off...
- Page 7 General Filter Replacement Intervals...
- Page 8 DRAIN PURIFIED WATER WATER WATER...
- Page 11 To avoid danger of suffocation, keep plastic bags away from children and pets. Do not use plastic bags in cribs, beds, carriages or playpens. NOTICE It is normal for the water puri er to emit some noise and slightly vibrate when in use, this is normal.
- Page 12 Push the PE-tube into the fi ng. There is an exis ng mark at the end of the tube for you to confirm if the tube is fully inserted into the fi ng.
- Page 13 Step 1: Installing the 3-way valve Wrap the thread seal tape in thedirec on of the thread counterclockwise. When wrapping the thread seal tape, start from the 2nd tooth of the thread head with slight force and leave the 1s ooth unwound, wrap 8-10 turns.
-
Page 14: Step 2: Installing The Faucet
Step 2: Installing the faucet Φ... -
Page 15: Step 3: Installing The Drain Saddle
Step 3: Installing the drain saddle (Fig. 10) NOTICE: If you are installing the drain saddle on the horizontal pipe B, please install so the PE tube is located on the top of the horizontal drain pipe. (See Fig 11) Gaster Place the square gasket through the PE- tube and it to the inner wall of the... -
Page 16: Drain Water
Step 4: Connec ng the PE-tubes to the main unit DRAIN WATER Step 5: Checking for leaks... - Page 17 Connect the adapter and faucet to the unit cable connector then connect the plug to a 110-240V GFCI power outlet. on the front panel...
- Page 20 50/60...
Need help?
Do you have a question about the CFU20R1AWW and is the answer not in the manual?
Questions and answers