Bosch HMV8050 Service Manual page 17

B. REMOVING THE OUTSIDE CASE
(Figure 8)
(1) Remove the vent grille by removing two screws
securing it to the outside case.
(2) Remove two screws securing it to the air duct.
(3) Remove the mounting plate by turning the screws
(1 or 2 screws)securing it to the out case.
(4) Remove two screws on the left central edge and
one screw on the right central edge of Base plate.
Remove the Mount, All from the outside case by
removing one screw securing it to the outside case.
(5) Remove six screws of the rear cavity.
(6) Remove the outside case.
Door
Vent Grille
Controller
Figure 8
7-6
Mount,All
(1 or 2 screws)
Out Case
(3 screws)
Mounting
Plate