Advertisement
RECORDING
Is the power cord correctly connected to an outlet?
Are connecting cords and wires connected correctly?
Is the TIMER switch set to the OFF position?
Are the accidental erasure prevention tabs broken off of the tape
cassette?
Load the cassette tape
2]
for the recording.
e
lf using metal or chromium dioxide tapes, does the tape cassette
have sensor holes?
e
ls the program source ready to be recorded?
When using the AUTO BLE system for recording, refer-to the sec-
tion on AUTO BLE on page 12.
@ Depress the POWER switch to ON.
@ Press the EJECT button to open the cas-
sette door.
With
the
exposed
tape
surface
pointing
down,
insert
an
unrecorded
tape. The auto
loading function
will close the
cassette door automatically. Also, if the tape has any slack, the
tape slack prevention function will operate to take up any slack.
© Select the DOLBY NR switch
positions.
When
recording
material
using the Dolby
Noise
Reduction
System, press the DOLBY NR (ON/OFF) switch to the ON posi-
tion.
Then select type B or C using the DOLBY
NR (B/C)
switch.
NOTE:
Set the Multiplex filter (MPX FILTER) ON when recording
FM broadcast with Dolby NR system.
@ Press the REC switch.
When this switch is pressed, the tape deck is placed in the recor-
ding standby mode, and the recording indicator ( @ ), the play in-
dicator (» )and the pause indicator ( BM ) will light. The auto
monitor will switch to the source monitor ([SOURCE
| display will
light).
@ Adjust the recording level.
Adjust the recording level with the REC MASTER volume con-
trol. Fine adjustment of the left and right channel is done with
the REC LEVEL PRESET volume control.
10
Temporarily stop the tape run
@ When PAUSE switch is pressed, the
standby mode is cancelled and recording
starts.
The auto monitor will automatically switch to tape monitor
(TAPE)
display will light).
@ Press the STOP switch to stop the recor-
ding.
To temporarily stop the recording, press the PAUSE switch. To
resume recording, press the PAUSE switch again.
© Press the EJECT button to open the
cassette door and remove the cassette
tape.
Lightly close the cassette door with your finger after removing.
the cassette tape.
Cautions with recording
~
¢
The D0 mark on the meter scale indicates the reference level
of the Dolby noise reduction system.
e
In actual fact, the proper recording level differs slightly accor-
ding to the type of tape, the sound and the music being record-
ed. In order to make the most of the tape's characteristics and
produce good-quality recordings, it is important to check the
sound yourself by ear.
¢
The level meter may light up in a different way for recording
and playback. This is caused by the difference in the tape's
sensitivity and a slight deviation in this respect does not pose
any problems.
J
Advertisement
