Supplied Accessories - Onkyo TX-8511 Instruction Manual

Precautions
Supplied accessories
1. Warranty Claim
You can find the serial number on the rear panel, bi case ol' war-
ranly claim, please report this number.
2. Recording Copyright
Recording of copyrighted material for other than personal u.se is
illegal without permission of the copyright holder.
3. AC Fuse
The fuse is located inside the cha.ssis and is not user-serviceable.
If power does not come on. contact your Onkyo authorized service
station.
4. Care
From time to time you should wipe the front anil rear panels and
the cabinet with a soft cloth. For heavier dirt, dampen a .soft cloth
in a weak solution of mild detergent and water, wring it out dry,
and wipe off the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material,.thinners, alcohol or other chemi¬
cal solvents or cloths since these could damage the finish or
remove the panel lettering.
5. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME.
READ THE FOLLOWING SECTION CAREFULLY.
• Some models are designed for use only with the power supply
voltage of the region where they are sold.
European and Australian inodeIs:AC 230V, 50H/.
U.S. and Canadian models: AC 120V, 60H/,
Worldwide model: AC 220-230V/I20V swiichable.
50/60H7.
Other: AC 220V. 601 Iz
• Vuitage Selector (Rear I'anel)
Worldwide models are ei|uipped with a voltage .selector to con¬
form to local power supplie.s. Be sure to set this .switch to
match the voltage of the power supply in your tirea before
plugging in the unit. (See below.) Models without a voltage
.selector can only be u.scd in areas where the power supply is
the same as that of the unit.
• The jtower does not shut off completely by just turning the
power off. So power cord should be removed from AC outlet
when not in use fora prolonged time.
Before operating this
Remote control RC-329S (1)
Battery (size AA. R6, or UM-3) (2)
AM loop antenna (1) T-shaped FM antenna (1)
unit
Setting the voltage selector
(worldwide mod^^nly)
1. Determine the proper voittige for your
area: 220-230 V or 120 V.
2, If ,the .setting on the voltage .selector is
not correct, insert a screwdriver into the
groove in the switch and slide the
switch completely to the right (120 V)
or the left (220 - 230 V), whichever is
appropriate.
Setting the tuning step fre- ;
quency (worldwide model only)
The worldwide model is eijuipped with a
switch that controls the AM (9 kHz/
10 kHz) band tuning steps.
Please .set this switch to match the tuning
step frequency in your area.
U.S. & Canada: USA
Other areas: OTHER