Table of Contents
Advertisement
6.
Insert threaded end of support rod (G) Fig. 20,
through slot in back of saw and through hole (H) in rear
trunnion. Fasten support rod (G) Fig. 20, to trunnion
using star washer and nut (J) Fig. 21. NOTE: Thread nut
(J) onto threaded end of support rod as far as possible by
hand. Using a wrench to hold nut (J) Fig. 21, tighten rod
(G) Fig. 22, using a small screwdriver (K) or similar
device through hole in end of rod (G) as shown.
8.
Assemble splitter bracket (M) Fig. 24, to lower bracket
(L), using one inch-long hex head screw (N), lockwasher
and flat washer. Do not fully tighten screw (N) at this
time. Loosely reassemble screw and plate (B) Fig. 17
removed in STEP 3.
Fig. 20
7.
Assemble lower bracket (L) Fig. 23, to rod (G) and
snug up with 2 one inch-long hex head screws (S) and
lockwashers, from underneath bracket (L).
--
11
Advertisement
Table of Contents
