Setup; Operation - ETEKCITY Lasergrip 774 Manual

Setup

1. Op e n th e b a tte r y co m p a r tm e n t and
r e m o v e t h e b a t t e r y n o t i c e s t r i p .
2 . T a k e t h e b a t t e r y f r o m t h e
c o m p a r t m e n t a n d r e m o v e t h e p l a s t i c
w r a p p i n g e n c a s i n g t h e b a t t e r y .
3 . C o n n e c t t h e b a t t e r y t o t h e d e v i c e
u n d e r t h e c o r r e c t p o l a r i t y .
4. Place the battery back into the
c o m p a r t m e n t .
5. Re-seal the battery compartment,
making sure the inside wiring does
not get pinched by the compartment
lid.
PAIR

Operation

Surface Temperature
NOTE: The Lasergrip cannot measure
the temperature of objects behind glass.
Inaccuracy may also occur when exposed
to steam, dust or any other contaminants in
the air.
1. Once the battery is properly
installed, press the measurement
trigger to activate the
2. Point the Lasergrip towards
surface of measurement.
3. Press and hold the measurement
trigger and the laser will
aiming guidance.
4. Keep holding the trigger as you move
the Lasergrip if you wish to live scan
the surface area for temperature
measurement.
5. Once the laser is pointed to the
desired point of measurement,
5
release the trigger and the LCD
display will lock the calculated
temperature.
6.Press
again to
Measurement
device.
the
activate for
NOTE: The Lasergrip LCD will display 'H'
when the measured temperature is above
the measurable range, and will display'LO'
when the measured temperature is below the
measurable range.
the measurement trigger
make another measurement.
HOLD for continuous
temperature
reading
lock the
RELEASE to
temperature
reading
once