Buyer Must-Read - Philips Electrical User Manual

1. BUYER MUST-READ

Please read this manual carefully before use and preserve the instruction manual for future reference.
Requirement that if not followed, could result in serious accident.
The following contents are closely related to safety issue, please follow the requirement strictly.
Requirements that, if not followed,
couldresult in serious injury or death.
This symbol indicates: Please pay attention!
It is used in conjunction with the above
"WARNING" and "ATTENTION" to draw your
attention, please read it carefully and strictly
comply with it.
SAFETY REGULATIONS
● Failure to follow the instruction of this manual may cause �re, resulting in property damage, personal injury or
death.
● Must install the device according to the instruction manual, otherwise may cause water leakage, �re, electric
shock.
● The installation and commissioning or maintenance must be carried out by factory authorized personnel to
ensure that the machine is in normal working condition. Personal installation or maintenance without factory
authorization resulting in the product cannot reach the normal state or performance, the factory is not
responsible.
● Special groups such as children, the elderly, and the disabled should be supervised by normal adults.
● Do cut-off power supply before any maintenance or repair. Any modi�cation or maintenance work must be
carried out by authorized service people.
WARNING
● Check and make sure the ground wire is well connected with ground otherwise the faulty and leakage can
cause electric shock.
● Circuit construction should follow the Speci�cation for urban cabling. Failure to follow the regulations can
result in �re and electric shock.
● Please make sure to use 220V~50Hz power supply for electric water heater.
● Make sure to install a leakage protection switch, or the �xed line connected to it must be equipped with this
such a device. When it is disconnected, the minimum distance between all touch points is 3mm. Whether the
electric meter capacity, leakage protection switch, electric wire can meet the power requirements of the
water heater, see the "Technical performance parameters", Leakage protection switch must be installed in a
dry place 1.6 meters above the ground and ensure that water does not splash in this location while in use.
● Do not use power strips or removable sockets.
● Electric water heater must be installed indoors, where the ambient temperature is above 0C°. When the
ambient temperature is below 5 C°, please make sure to take anti-freezing measures to prevent water leakage
and electricity leakage accidents caused by damage of the internal �ttings of the device due to freezing.
● A stream of hot water �owing out of the water heater may cause Scalding. Do not directly put any parts of
your body under hot water when you turn it on. Adjust the water temperature �rst, and wait for the water
�ow and water temperature to stabilize before use.
● The safe service life of this device is 8 years! If the product is still used after this time, it may cause �re or injury
due to the deterioration over time.
WARNING
ATTENTION
This symbol indicates, that improper use may cause
minor injuries to the user or damage to property.
PROHIBITIONS
This symbol indicates that
this operation is prohibited!
EN 1
Note
This symbol indicates
Please follow the
instructions!