Advertisement
Front panel
Connector panel
Front panel
@
POWER indicator
Lights when you set the POWER switch @ to ON.
@® POWER switch
Set the switch to ON to turn on the power.
Connector panel
© GENLOCK IN connector (BNC type)
Inputs the external sync signal (VBS = Video, Burst, Sync
or BS = Burst, Sync). Connect to the sync output connector
for synchronization when using two or more cameras.
Whether the sync signal is input depends on the video
camera and cable being used.
|
To confirm whether the sync signal is being input, see
"Connections" on pages 5 to 8.
© VIDEO OUT connector (BNC type)
Outputs the video signal from the camera.
© S VIDEO connector (Mini DIN, 4-pin)
Outputs separate Y and C signals. Output of the separate Y
and C signals depends on the video camera being used.
—4—-
Motors ilelom-larem mle laletlelameym or: l ac
POWER
indicator
POWER
switch
GENLOCK IN connector
VIDEO OUT connector
S VIDEO connector
CAMERA connector
MODE selector
CAMERA connector
© AC IN connector
For detailed information, read the instruction manual of the
video camera.
@ CAMERA connector (12-pin)
Outputs DC power and the video signal and inputs external
sync signal. The output/input signal depends on which
camera 1s connected.
Connect to the DC power input connector of the camera
using the CCMC-12P02/05/10/25 camera cable.
@ MODE selector
In most cases, set the selector to the upper position "1".
When connecting the unit to the DXC-930/930P/960MID
with the CCMC-12P02/05/10/25, set the MODE selecorx to
the lower position "2".
For details, see "System to supply DC power and output the
video signal" on page 8.
|
@ CAMERA connector (4-pin)
Outputs the DC power.
Connect to the DC power input connector of the camea
using the CCDC-5/10/25/50/100/50A/100A camera c b Je.
© AC IN connector
Connect to an AC power source using the AC power o xd
(supplied).
CMA-D2> 2CE
Pe
hae
2: end
Kit
enc
N al
A aco
ear
illag
a
'
a
¥
:
{
3
:
i
i é
j
53
i
é
ei
a
'
%
i
i
z
%
i
Advertisement
