Single Mode - Flash F6000360 User Manual

User Manual • Instrukcja Obsługi
slider is at the top and MASTER ‚B' slider is
at the bottom).
3. Create the desired scene using the sliders
from 1 to 48, setting values in % or DMX
4. When the scene is complete, press the
RECORD button to store the scene in memory
as a step.
5. Repeat steps 3 and 4 until all steps are
programmed into memory. Up to 1000 steps
can be stored in memory.
6. Select CHASE BANK or SCENE MASTER
to save the entire program. Press the PAGE
button to select the appropriate page ( 1 - 4 )
where you want to save the program.
7. Press and hold one FLASH 25-48 button
and then press the RECORD button. All LEDs
will light up, which means the scene has been
stored in memory.
8. You can continue programming or quit. To
exit the programming mode, press and hold
the EDIT button and the RECORD LED should
turn off.
EXAMPLE: Programming 16 steps from 1-32
channels in sequence, to the FLASH button
25 from page 1
1. Start recording mode
2. Move the MASTER ‚A' and MASTER ‚B'
sliders to the maximum and the FADE slider
up
3. Press the MODE SELECT button to select

SINGLE MODE

4. Move the channel 1 slider to the top
5. Press the RECORD button to save this step
to memory
6. Repeat steps 4 and 5 until channel faders 1
through 32 are programmed
7. Press the PAGE button to light the first
PAGE LED
8. Press the button FLASH 25 after pressing
the RECORD button, all LEDs will light up,
which means that the programming was
successful and the sequences have been
saved to memory.
2. Editing
2.1 Starting the Edit mode
1. Start recording mode
2. Use the PAGE button to select the page of
the program you want to modify
3. Press the MODE SELECT button to select
the CHASE < > SCENES mode
4. Press and hold the EDIT button
5. Press the FLASH button of the selected
program to be modified
6. Release the EDIT button, the scene LED
should be on, indicating that you are in edit
mode
2.2 Deleting a program
1. Start recording mode
2. Use the PAGE button to select the page
where the program to be deleted is stored
3. Press and hold the EDIT button, then press
the FLASH button twice from the range of 25-
48
4. Simultaneously release the EDIT button. All
LEDs will light up, indicating that the program
has been cleared
2.3 Deleting all programs
1. Press and hold the RECORD button
2. Press FLASH 1, 4, 2 and 3 in sequence.
all LEDs will light up, which means that all
programs stored in the memory have been
cleared.
2.4 Clearing a Scene or Program Scenes
1. Start recording mode
2. Start recording the scene or scenes
3. If you are not satisfied with the scene or
scenes, you can press and hold the RECORD
button and press the REC CLEAR button, and
all LEDs will turn on, which means the scenes
have been cleared.
2.5 Deleting a step or steps
1. Start recording mode
2. Press the STEP button to go to the step you
want to delete
3. When you reach the step you want to delete,
press the DELETE button, all LEDs will turn on,
indicating that the step has been deleted.
4. Repeat steps 2 and 3 until all selected steps
are deleted