Advertisement
Available languages
Available languages
User Manual • Instrukcja Obsługi
1. INTRODUCTION
THANK YOU FOR PURCHASING DMX CONSOLE. FOR SAFETY REASONS AND TO ENSURE
THE TROUBLE-FREE OPERATION, CAREFULLY READ THE INSTRUCTIONS.
I. PRODUCT DESCRIPTION
Congratulations on purchasing your new DMX
console. The console has a system controlled
by microprocessors and is fully compatible
with the following standards: DMX-512 and
MIDI. The console is equipped with 48 DMX-
512 channels and MIDI standard, 96 programs
can be programmed on 4 pages, and the
maximum number of steps does not exceed
4500. to the price and size and enables easy
operation and trouble-free operation.
48 DMX channels
96 sequence programs
3 digit display
High-end digital technology
Power independent memory
MIDI standard and DMX ports
Extensive editing program
Programs can run synchronously
W A R N I N G ! The Led Moving Head (LMH) has a powerful pan motor. The torque reaction when
the head is panned suddenly can cause the base to move if the fixture is standing unsecured on
a surface. Do not apply power to the LMH unless the baase is securely fastened to a surface or to
rigging hardware.
W A R N I N G ! Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp. Lock
each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full 900 clockwise.
W A R N I N G ! When clamping the fixture to a truss or other structure at any other angle than with
the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not use any type of
clamp that does not completely encircle the structure when fastened.
W A R N I N G ! Position or shade the head so that the front lens will not be exposed to sunlight or any
other strong light source from any angle - even for a few seconds. S e e F i g u r e 1 . The LMH lens
can focused the sun's rays, creating a potential fire hazard and causing damage.
I M P O R T A N T ! Do not point strong light output from other fixtures at the LMH, as intense
illumination can damaged the display.
Figure 1. Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
Shield or shade the head if necessary.
Read the instructions carefully, it will give you
comprehensive knowledge about operation
and safety of use. Keep the instructions with
the device.
II. REMARKS
1. To prevent or minimize the risk of electric
shock or fire, do not use the controller in the
rain or in high humidity.
2. Frequent erasing of the memory may cause
damage to the memory chips, so be careful
and reduce the frequency of this activity to
eliminate the risk.
3. Use only recommended AC/DC adapters.
4. Keep the original carton in case the device
is serviced.
5. Do not spill water or other liquids near the
device.
6. Make sure that the mains voltage parameters
match those required by the device
WARNING
Advertisement
