Table of Contents
Advertisement
MAINTENANCE AND ADJUSTMENT
1
1. Soap and water
2. Pre-filter
Inspection and cleaning:
3.
Wash the foam pre-filter in soap and water. Allow
2
it to dry.
4.
Check the pre-filter. If damaged or dirty, replace
it.
NOTICE
Do not wring out the foam pre-filter, this could
cause it to tear.
5.
To install the elements, reverse the above steps.
NOTICE
The pre-filter has a notch on one side. It will only fit
in the case one way. Serious engine damage can
result from an improperly positioned filter.
DRIVE BELT
To remove the drive belt:
TIP
To access the drive belt, remove the seat and lift the
cargo bed up.
1.
Set the drive select lever halfway between for-
ward and reverse.
2.
Pull up on the drive belt and push it outward over
the edge of the secondary sheave.
46
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Advertisement
Table of Contents
