Use Philips Easylink - Philips 32PFL7603D User Manual

2. Press Æ to enter the list.
3. Press ï or Î to select a connector.
4. Press Æ to enter the list.
5. Press ï or Î to select the device attached
to the connector.
6. Press OK to select the device.
7. Repeat the procedure until all devices are
correctly assigned to connectors.
8. Press MENU to exit.
7�4�2 Assign the AUDIO IN mini-jack
connector
If you connect audio from a PC to the AUDIO
IN mini-jack connector at the back of the TV,
you must associate it to the HDMI connector.
1. Press MENU on the remote control
and select TV menu > Installation >
Connections > Audio In L/R.
Connections AUDIO IN L/R
... None
HDMI 1
EXT 3
HDMI 2
HDMI 1
HDMI 2 HDMI 3
HDMI 3
Side
AUDIO IN L/R
2. Press Æ to enter the list.
3. Press ï or Î to select the HDMI
connector used by the PC.
4. Press MENU to exit.
7�4�3 Assign a channel decoder
Decoders that decode digital channels can be
connected to EXT 1 or EXT 2 (SCART). You
have to assign the TV channel as a channel to
be decoded. Then assign the connection where
the decoder is connected.
1. Press MENU on the remote control
and select TV menu > Installation >
Decoder > Channel.
2. Press Æ to enter the list.
3. Press ï or Î to select the channel to
decode.
4. Press Í and go back to select Status.
5. Press ï or Î to select the connector used
by the decoder.
6. Press MENU to exit.
7�5

Use Philips EasyLink

Your TV supports Philips EasyLink, which
enables one-touch play and one-touch standby
between EasyLink-compliant devices. Compliant
devices must be connected to your TV via
HDMI and assigned as described in Section 7.4.1
Assign devices to connectors.
7�5�1 Enable or disable EasyLink
1. Press MENU on the remote control
then select TV menu > Installation >
Preferences > EasyLink.
2. Select On or Off.
7�5�2 Use one-touch play
After enabling EasyLink, press play on your
device. The TV automatically switches to the
correct source.
7�5�3 Use one-touch standby
Press and hold . STANDBY on the TV
or device remote control for at least three
seconds. The TV and all connected HDMI
devices switch to standby.
EN-45