Advertisement
Chapter 1
SAFETY WARNINGS / PRECAUTIONS
KEEP THIS MANUAL – DO NOT LOSE
MOTORIZED COUPLANT PUMP
THIS MANUAL IS PART OF THE
RETAINED FOR THE LIFE OF THE PRODUCT. PASS ON TO SUBSEQUENT OWNERS.
Ensure any amendments are incorporated with this document.
CAUTION!
The
designed for a specific use. Using the
PUMP
outside of its intended use could cause damage to the product.
Read and understand this manual before using.
CAUTION!
• Do not freeze.
• Use proper PPE
(personal protective equipment, i.e. gloves and
glasses)
.
• Do not connect input to pressurized fluid source.
• Do not pump fluids hotter than 70° C
WARNING!
• Use with GFCI
(ground fault circuit interrupter)
• Do not use in an explosive environment.
• Service by qualified personnel only.
• Do not use in a wet environment.
• Do not use with flammable liquid.
WARNING!
Disassembling any of the components in this product, beyond the
instructions in this user manual, could void the regulatory certifications and/
or effect the safety of the product.
The WEEE symbol indicates that the product must not be disposed of as
unsorted municipal waste, but should be collected separately.
Chapter 2
SPECIFICATIONS
2.1. Intended Use
The motorized couplant pump aims to pump couplant fluid (non-toxic and Non-
flammable) from a reservoir to a scanner for ultrasonic inspection.
2.2. Specifications
Power Input:
Output:
Maximum Fluid Viscosity:
Part Number:
2.3. Operating Environment
The motorized couplant pump is designed for use in an industrial environment that is
between -20° C
(-4° F )
and 50° C
The motorized couplant pump is designed for use in a dry, non-explosive environment.
MOTORIZED COUPLANT PUMP
MOTORIZED COUPLANT
(158° F)
.
power source.
DO NOT DISASSEMBLE. No user-serviceable parts.
100-277 VAC, 50/60 Hz, 1.5 Amps
414 kPa (60 psi), 3.4 L/min (0.89 GPM) maximum.
30 cSt
CMA015
(122° F
).
Chapter 3
3.1. Motorized Couplant Pump Component Identification
AND MUST BE
is
4
3.2. Pump Setup
1.
Ensure the power switch is OFF
(Fig. 1-2).
2.
Place the inlet filter (Fig. 1-5) into a
reservoir of non-toxic, non-flammable
couplant (Fig. 2). Ensure the opposite
end of the inlet hose is connected to
the motorized pump's inlet connection
(Fig. 1-3).
3.
Connect the irrigation kit (sold
separately) to the outlet (Fig. 3).
4.
Plug the power cord into a GFCI
(ground fault circuit interrupter)
protected power source.
Chapter 4
OPERATION
1.
Ensure the flow control valve (Fig. 1-8) is
rotated clockwise, preventing unwanted
couplant discharge upon unit activation.
2.
Turn the power switch to ON (Fig. 1-2).
3.
Open the flow control valve
counter-clockwise)
flow is achieved (Fig. 4).
4.
Close the flow control valve
clockwise)
PREPARATION FOR USE
1
2
3
8
7
6
5
- Pump Assembly
Fig. 1
(rotate
until the desired
(rotate
to stop the fluid flow.
1
Handle
2 Power Switch
3 Inlet
4 Inlet Hose
5 Inlet Filter
6 Power Chord
7 Outlet
8 Flow Control
Valve
1
- Inlet filter in couplant
Fig. 2
- Connect irrigation kit to outlet
Fig. 3
- Control couplant with flow control valve
Fig. 4
Advertisement
