Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for iSi Blue-X-Focus
Summary of Contents for iSi Blue-X-Focus
- Page 1 User Manual and Service Instructions for Blue-X-Focus Version 2 Support: Phone: +49-561-739798-0 Email: info@isi-sys.com www.isi-sys.com 2003-2020 by isi-sys GmbH Wasserweg 8, 34131 Kassel, Germany Blue-X-Focus V2 © isi-sys GmbH 2020...
-
Page 2: Technical Description
Ambient temperature (Ta): -15° - +40° C Surface temperature: 60°C 2x 1/4" 99,00 137,00 90,45 - 108,45 BNC Trigger (TTL) 3x 1/4" DC Input Power switch Operation mode switch Stepless intensity control optional polarization filter Page 1/7 Blue-X-Focus V2 © isi-sys GmbH 2020... -
Page 3: Key Buttons
Save these documents together with the technical brochures and ac- cessories for later reference. Note: It is only allowed to set up and used the system persons instructed and trained by isi-sys or through their authorized partners. - Page 4 Installation of Blue-X-Focus and Power Supply CAUTION! The following facts of this section are important instructions for the installation of the devices, which must be strictly followed and observed for the safe operation of the system. • Allow adequate ventilation around the devices so that heat can properly dissipate.
- Page 5 • Always disconnect the power supply from the power socket if it is not in use or in operation. • In the case of overthrowing, falling down and/or jaring heavily a Blue-X-Focus has to be checked by isi- sys for damages...
- Page 6 The Blue-X-Focus can be operated standalone in continuous wave mode when connected to the power sup- ply through the lamp connector cable. To operate the Blue-X-Focus in pulse mode, Lamp has to be connected to a trigger device (TTL Signal). The setup scheme shown below illustrates possible setup schemes. The hig- her power of 180W can only be reached through pulse mode.
-
Page 7: Recommended Usage
The light shuts off for 20 seconds before turning on again The lamp is reached the thermal limit for safe operation. Consider to lower the power level and make sure that air circulation is possible. Blue-X-Focus V2 © isi-sys GmbH 2020 Page 6/7... -
Page 8: Maintenance
Explanation for symbols Maintenance For a secure operation of the Blue-X-Focus, it has to be maintained. Therefore: before using it has to be checked visually. Liability limitation For all injuiries and/or damages to people and/or objects, which are caused by using isi-sys products in a way that they are not intended for the user is liable - not the manufacturer.
Need help?
Do you have a question about the Blue-X-Focus and is the answer not in the manual?
Questions and answers