Table of Contents
Advertisement
ST-350 Service Manual
*STEP 4. Adjust Setting Values for CIS TOP, BOTTOM and IR
Checked CIS TOP, Bottom and IR Values are out of range, you need to adjust the values manually.
There are two kinds of method for adjusting CIS TOP, Bottom and IR Values.
If the values are too high or low from the range, you have to adjust them in Manual Mode. (STEP
4-1)
After adjust the values in Manual Mode, you have to do STEP1 Auto Mode Setting again.
If you skip Auto Mode Setting, the adjusted values do not apply.
If the values are little high or low, you can adjust them in Gain ADJ Mode. (STEP 4-2)
After adjust the values in Gain ADJ Mode, you don't need to do STEP 1 Auto Mode Setting.
STEP 4-1. Manual Mode
1) Go to "page1".
Hitachi Terminal Solutions Korea Co., Ltd.
106
Advertisement
Table of Contents
