Kenwood TM-231A Instruction Manual page 7

3-2. CONNECTION
3-2-1. Mobile Installations
Cautions:
2. After installation and wiring have been completed go
back and check your work to ensure that you have not
made any errors, before you reconnect the negative bat-
tery lead.
5. Do not remove the fuse even if the power cable is too
long.
A. Battery Connections
Make sure the positive (+) and negative (—) lead polarity is correct
when connecting to the battery.
aa Engine compartment ~— }—+ Passenger compartment
: Fuse
(i =5)
To the
transceiver
t
Chassis or
fire walt
B If the wiring hole in the fire wall or chassis is too small, disas-
semble the fuse holder to thread the wire through the hole.
From passenger
compartment
Thread like this
B. Ignition Noise
This transceiver has been designed to suppress ignition
noise, however, you may occasionally encounter an instal-
lation where the use of suppressor type plugs might be called
for.
3-2-2. Fixed Station
PS-430 or the PS-50 are recommended.
CAUTION: