Memory Recall; Memory Shift - Kenwood TM-231A Instruction Manual

@ Cail Channel
1. Press the VFO key to select
the VFO mode.
2. Select the desired operat-
ing frequency, tone data
etc. (For example 449.920
MHz)
3. Press the F key momentar-
ily. The F indicator will turn
on and the Memory chan-
nel indicator will turn on.
(Channel 8 in the example)
4. Press the CALL key within
40 seconds of pressing the
F key to enter the data into
memory. A long beep will
sound and the F indicator
and memory channel indi-
cators will turn off to con-
firm data entry.
Sake TS Te TS er
4-4-6. Memory Channel Recall
When recalling a memory channel using this procedure you
will not be able to adjust the frequency or tone data. The
memory channel acts very much like the old crystal con-
trolled radios, i.e. the data is fixed and cannot be changed
by mistake.
1. Press the MR key to select the MR mode. The memory
channel indicator will turn on in the display.
2. Rotate the tuning control or press the microphone
UP/DOWN switches to select the desired memory channel.
24
4-4-7. Memory Shift
Using this function you can copy the contents of a memory
channel or CALL channel to the VFO without changing the
data in memory. This will allow you to change the tone data,
or tune normally if you wish.
1. Press the MR key or CALL
key to select the appropri-
ate mode.
2. Press the F key momentar- a)
ily. The F indicator will
light.
3. Press the VFO key within
40 seconds of pressing the
F key. The F indicators will
turn off to signal the data
has been successfully
transferred to the VFO.
the VFO.
Note:
If an Odd Split Memory channel is selected you will only
transfer the Receive data. Transmit data will not be copied.