REVISION June 2022 • Audimax 362HD processors are designed for rack Solidyne® All rights reserved. No part of this manual montage in 19” standard racks. Also it can be used may be reproduced, copied or transmitted in any on a table or desktop, quitting the lateral supports.
RJ45 for the analogical audio signals; and 7 -15 (optional) Brown & White are wired using CAT-5 shielded twisted pair (STP). 8 +15 (optional) Brown With the arriving of audio over IP (AoIP) several SOLIDYNE Audimax 362HD Page 5...
(balanced or USB). Is very important to have an appropriate ground When the unit is set to HD mode: installation. Pre-emphasis for FM is disabled (and therefore de- • emphasis on audio outputs is disabled). Page 6 Audimax 362HD SOLIDYNE...
75KHz of deviation (100%), measurred at an FM Modulation Meter (like If some residual humming appears when the system Solidyne VA16) o using the instrument of is started up; turn off the unit. If humming disappears, the tranmiter. check the 462 input connections. If the humming still here;...
1.6 Work settings 1.6.1.1 USB for external streaming Requires Solidyne Audimax 362 HD / USB. Using USB is independent from MPX. This makes it 1.6.1 Processor as FM stereo coder possible to use the same audio processing on-the-air and on the webcast. The processor receives the It's normal use as audio processor for FM.
Automatic input gain control (AGC) eliminates with uniform loudness at times, variations in characteristics of the operation of the regardless of the characteristics of the input mixing console level, compensates signal. differences in level of the recorded material. That is, SOLIDYNE Audimax 362HD Page 9...
Turning the knobs to the right, a boost in this band takes place. When you boost a band, the action of the compressor for this band increases. NOTE: Dynamic Equalizer make changes over the attack times of mutiband compressor. Page 10 Audimax 362HD SOLIDYNE...
7 and symmetrical the human voice waveform is another 10 stages of processors, the distortion of each one of the techniques that Solidyne has introduced stage must be smaller than 0.01%. Greater internationally (see mentioned article AES). Today,...
EVEN THROUGH RECEIVERS THAT HAVE VALUES OF DISTORSION 50 TIMES GREATER. This, of course, is not a novelty for the conscious audio engineers around the World. Therefore, the line of SOLIDYNE processors has distortion values smaller than 0,02%. Few controls, easy adjustment... psychoacoustic...
Stage 3: Level Input Control noise of the microphones. To avoid this, Solidyne processors incorporate a linear expander, previous The Audimax 362HDHD has an automatic control to the compressor stage.
For Rock & Pop is advisable to increase the energy bands so that the sound has 3. To improve the audio quality. Processing more "punch". completely eliminate the "flat sound" sensation, Page 14 Audimax 362HD SOLIDYNE...
It uses digital technology to generate the MPX values for the interleaving. This phenomenon signal. This technique, created by Solidyne, allows indicates that is possible to increase the modulation to obtain a perfect coder with distortion 10 times...
Measured from internal Stereo coder jumper to MPX out Audio input 2 Vpp for 100 % MPX output (4 Vpp) Frequency Response 15 Khz/5 order elliptic LP filter 20-15.000 +/- 1 dB Attenuation at 19 Khz > 50 dB Page 16 Audimax 362HD SOLIDYNE...
Need help?
Do you have a question about the Audimax 362 HD and is the answer not in the manual?
Questions and answers