Line Voltage - Pioneer SX-434 Operating Instructions Manual

NN F351 EE
LINE VOLTAGE AND FUSE AND REAR PANEL
Each design of LINE VOLTAGE and FUSE of this
model differs according to each destination to be
delivered.
How to operate the SX-434 is quite the same for
each version. However, each rear panel differs
according to LINE VOLTAGE and FUSE designed
for each version.
Fig. A shows the LINE VOLTAGE of a 220V only
model.
Fig. B shows the LINE VOLTAGE and FUSE ofa
5 line voltage (110V, 120V, 130V, 220V, 240V)
whose line voltage and fuse can be changed and set
as follows:
CHANGING LINE VOLTAGE SETTING AND
FUSE
To remove the fuse, turn the fuse cap located on
the line voltage selector in the direction indicated
by the arrow. Then remove the fuse plug from the
unit. Put the fuse plug back so that the proper line
voltage marking can be seen through the cut in the
edge of the plug. Whenever the position of the
selector is changed, check the rating of the fuse.
A 1.5A fuse is to be used for either 220V or 240V
operation and a 3A fuse rating for 110V, 120V or
130V operation. If the rating of the fuse is correct,
replace cap.
FUSE REPLACEMENT
When the fuse blows, remove the fuse cap and
replace the fuse with a new one. Fig. C.
220V model
AC INLET
5 Line Voltage model
O
PHILIP:
SCREWDRIV SOCKET oS
Ko 2° cites rimeRtiR
cuse CAP
Fig. C