Commodore 1084 S-D1 Service Manual page 20

NOTE:
This adjustment requires trubber Wedge Kit.
1. Loosen the clamping screw of deflection yoke to allow the yoke to tilt.
2. Place a wedge as shown in Fig. 15 temporarily. (Do not remove cover paper on adhesive part of the wedge).
3. Tilt front of the deflection yoke up or down to obtain better convergence in circumference. (see Fig. 14) Push the
mounted wedge into the space between picture tube and the yoke to hold the yoke temporarily.
. Place other wedge into bottom space and remove the cover paper to slick.
. Tilt front of the yoke right or left to obtain better convergence іп circumference. (See Fig. 14)
. Hold the yoke position and put another wedge in either upper space.
. Detach the temporarily mounted wedge and ру: it in another upper space.
Stick it on picture tube to fix the yoke.
8. After placing three wedges, recheck overall convergence.
Tighten the screw firmly to hold the yoke tightly in place.
9. Stick 3 adhesive tapes on wedges as shown in Fig. 15.
NOV»
O) ටෘ + ০৩ අර A
со со ~
DEFLECTION
YOKE
CONVERGENCE
MAGNET ASS'Y
30° К \30° >
RUBBER
WEDGES
ADHESIVE
GLASS CLOTH voice
TAPE
Fig. 15 Rubber Wedges Location
Fig. 16 Picture Tube Neck Components Location
18