Kenwood KR-200HT Instruction Manual page 22

Once the settings have been done, it is held in memory so re-
adjustment is not necessary even after the mode has been
changed to other modes.
Adjustments for surround pla
Select the DOLBY PRO LOGIC surround mode.
LO Te oe
F Select the CENTER MODE.
@ Press the SETUP key (on the remote
control unit).
ae
Nae
© Adjust the front speaker (left & right)
levels so that the left and right levels are
identical.
To decrease the
left channe! sound
To decrease the ey
right channel sound "7
© Press the SETUP key again to establish
the setup.
After this, the unit enters the condition
for "@ Adjust the volume level of each
speaker".
x
KR-200HT {En/K)
eSelect a surround mode according to the played source and your
system components.
Lights
Each press of CENTER MODE key switches the modes as follows:
. J) NORMAL : When the center speaker is a compact speaker.
[" '2 WIDEBAND ~_. When the center speaker ts a large speaker
3 PHANTOM : When no center speaker is used.
Adjustment procedure: Each press of the SETUP key switches the
adjusted items as shown below.
Adjusting the front speaker balance
Gi Adjusting the volume level of each speaker
EA Adjusting the delay time
End of setup
To cancel setup in the middie, press the SETUP key repeatedly until the
setup mode ts cancelled.
Left speaker Center position Right speaker
position indication position
SURROUND
ae ee oe ee
|
Balance setup
a
a