Kenwood KR-200HT Instruction Manual page 16

Preparation
eSwitch the VIDEO! display to TAPE1 or MD with the faliowing Each press switches the display.
operation.
© Select VIDEO1 with the INPUT SELECTOR.
@ Press and hold the AUTO key for more than 2 seconds.
DVIDEO1 ~ @TAPE1 —~—
SRNR ww pre orion mucha cies
The input sources are switched in the following order:
@ Select the source to be recorded.
P
Switched |
g
2: PHONO
®D VIDEO1 (TAPE1 or MD)
'CD
6) VIDEO2
Select an input
source other than
TAPE 1. E
© Put the cassette deck in record-pause ' The VIDEO! display can be switched to the display of other input by
mode. 4 using the procedure described in "Preparation" above.
. @For MD recording, refer to the instruction manual of your MD recorder.
© Play the source and start recording. 4 elt is not possible the VIDEO1 or MD input to TAPE1 because all of these
components should use the same INPUT SELECTOR position.
Teneo ee ee OES TRAD OR eT Ne
EELS ead NLEMRRPUN SNE 2 ahiareg sedan RE AEA AEA EDE ARSON DY, ES AIOE BSB EAI SON UE ei So ERD HE SCABIES ASHES SIE BIRR NE CAO NLAN GR 8008 A OARS ARR RDO ROL O t
Copying tape (Tape dubbing TAPE 2—> TAPE 1)
@ Press the TAPE 2 MONITOR key.
Nl TAPE2
BAND DISPLAY ve a MONITOA
@ Select a source other than TAPE 1.
INPUT SELECTOR
manual of the doubie cassette deck.
saa EE SER SEER EE b a r e s reas taet
© Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
@ Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
Regarding TAPE 2 MONITOR
KR-2O0HT [En/K]
di