Table of Contents
Advertisement
5.3 Operation instructions
Only use this lift on a surface that is stable, level and dry and not slippery, and capable of sustaining the load.
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift.
After reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on
lift. Always lift the vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle.
The lift must be only used in a static position for lifting and lowering vehicles.
Don't use the lift outdoor in strong breeze when the wind speed excesses 14m/s.
As the lift rises and lowers with rolling wheels directly contacting the floor, it is normal that certain scratches will be left due to
long time use.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over the
lift.
1. Make sure that you have read and understood the operation manual before operation.
2.
Load vehicle on lift carefully. Position the lift adapters to contact at the vehicle manufacturer's recommended lift points.
3. Push the UP button to
raise lift until adapters contact vehicle.
4.
Check adapters for secure contact with vehicle. Raise lift to expected working height.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Release the safety lock by holding the mechanical lock releasing handle before attempting to lower lift.
2. Push down the lowering handle.
3. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift area.
5.4 Move the unloaded lift
DO NOT attempt to move the lift when it is loaded.
Installation, Operation and Parts Manual
15
MJ-TS6600
nel to
Advertisement
Table of Contents
