Table of Contents
Advertisement
RECORDING AND PLAYBACK BY TAPE DECKS
Connecting a Tape Deck
Connect the input terminals of a tape deck to TAPE
REC terminals of the amplifier, and its output termi-
nals to the PLAY terminals.
The DIN socket can be used only if your tape deck
is equipped with a similar socket.
It is manu-
factured according to the German industrial standard
to permit tape recording and playback from a single
cable with a special 5-pin plug on each end.
Should you wish to connect more
than two tape
decks, you may connect it to the 4-CH ADAPTOR
terminals.
The 2-CH OUTPUT terminals have the
same electrical function as the REC terminals, while
the INPUT terminals are equivalent to the PLAY
terminals.
Note:
Do not connect the tape deck(s) to the pin
jack terminals and DIN socket simultaneously.
:
es
TAPE se
az 4-CH ADAPTOR
2-CH
REO YPLAY
REC
PLAY
GUTPUT
INPUT
fom
,eo200
'9oao00d.
eek
RECORD—_.
| PLAYBACK
DIN RECORD/
PLAYBACK
CABLE
NOTE:
Do not connect tape
deck(s) to pin jack terminals
and
DIN
socket
simultane-
wm
RIGHT CHANNEL
ously.
=== LEFT CHANNEL
Recording & Playback Procedure
Recording
1. Set the Selector Control to the program source
you wish to record.
2. Adjust the recording volume control of the tape
deck to preset the recording level.
3. Start the tape deck in the recording mode.
4. To monitor the recording as you make it, push
down the Tape Monitor Switch to PLAYBACK.
Be sure to set the monitor switch of the tape deck
to the playback mode as well.
Playback
1. Set the Tape Monitor Switch to PLAYBACK.
2. Start the tape deck in the playback mode.
3. Use the amplifier's other switches and controls
to suit your taste or room acoustics.
Procedure for Copying a Recorded
Tape
Oo If you want to copy a recorded tape, connect one
tape deck for playback to the TAPE
terminals, the
other for recording to the 4-CH ADAPTOR
termi-
nals.
© By operating the 4-Channel Adaptor Switch, you
can monitor the recording as you copy it from one
tape deck to the other.
To monitor
the recording
before
it is copied, keep the 4-Channel
Adaptor
Switch at OUT.
To monitor the recording after it
is copied, push down to IN.
Notes about Recording
1. Monitoring of recorded sound is possible only if
the recording tape deck is equipped with separate
heads for recording and playback.
Otherwise, set
the Tape Monitor Switch to SOURCE and listen to
the original input sound before it is recorded.
2. The various switches and controls on the AU-
6500 do not affect the sound recorded into the tape
deck.
They only adjust the sound from the speaker
systems or headphones.
Advertisement
Table of Contents
