Table of Contents
Advertisement
Connecting Speaker Systems
If you are connecting only one pair of speaker
systems to the AU-6500, they may have any im-
pedance from 4 to 16 ohms.
Connect them to the
SYSTEM-A
or -B terminals on the rear, making
sure not to confuse the left and right cables, plus and
minus leads on the amplifier and speaker ends.
But if you wish to connect two pairs of speaker
systems and drive them simultaneously by turning
the Power/Speakers Switch to A+B, each speaker
system should have impedance of 8 to 16 ohms.
Using a system with lower impedance could result
in a breakdown of the amplifier.
Connecting a Turntable
Connect it to the PHONO 1 or 2 terminals on the
rear.
Fot
best results,
use
a turntable
with
a
magnetic pickup cartridge.
Connecting a Tuner
Connect
the output
terminals of a tuner to the
TUNER
input terminals on the amplifier's rear
panel.
Connecting Grounding
Be sure to connect the grounding terminal (or lead)
of the turntable and tuner to the grounding termi-
nal of the amplifier. It may suppress the hum noise
which may otherwise occur.
PRE
MAIN
OUTPUT
INPUT
Operating Procedure
1. Set the Selector Control to the desired program
source.
2. Set the 4-Channel Adaptor Switch to OUT and
the Tape Monitor Switch to SOURCE, unless you
want to use them.
3. Set the Power/Speakers Switch to as required.
4. Start the program source component
and play
the program source.
5. Use the amplifier's other controls and switches
to suit your taste or room acoustics.
Note:
To play a monophonic record on a stereo
turntable, follow the same procedure as for playing
a
stereo
record.
Better
results
are
normally
obtained.
|
Advertisement
Table of Contents
