Panasonic RX-FS50 Service Manual page 8

Conneci the 2 connectors (CP301, CP302).
Connector
(CP301)
Mechanism " " Connector
unit (CP302)
+ Check the main P.C.B8. as shown below.
Insulation
material
Mechanism Main PCB.
unit
(Solder side)
Locaie ihe insulation material between the main P.C.B.
and the mechanism unit to prevent from short-circuit.
Boss
% For recording mode,
press the boss of rec/play
switch.
* When installing the main P.C.B., align the headphones
jack and LED holder with the hole of rear cabinet ass'y.
Holes
Headhpone jack
LED holder
| RX-FS50
Notice for installation of tuner P.C.B.
Band knob ,,
Band knob
° When installing the tuner
P.C.B., align the boss of
band switch with band knob.
FINE TUNING
« Roiate the FINE TUNING
knob until the stopper faces
downward.
Band switch Tuner P.C.B.
Main Component Replacement
Procedures
1. Replacement for the pinch roller, erase head
anc rec / play head
- Follow the @ ( @ of the item 1 in checking
procedure for each P.C.B. on pages 3 and 4.
: Follow the » of the item 2 in checking
procedure for each P.C.B. on page 4.
i Removal of the pinch roller ass'y
° Release the 1 claw, and then
pull out the pinch roller ass' y.
<<. Pinch roller ass'y
Slot of lever
> Notice for insiallation of pinch roller ass'y
The pinch roller ass'y spring should be aligned
with the sloi of lever.