Advertisement
OPERATION
Power on/off
• To power on the earphones, open the charging case lid, the earphones will
automatically turn on.
• To power off the earphones, place them back in the charging case and close the lid.
Note: The headphones can also be manually turned on/off by pressing and holding the
MFB for 5 seconds.
When the charging box has low battery/ flat, the earphones will not automatically power off
when they are placed in the charging case. You need to manually turn off the earphones.
Note:
The earphones need to be disconnected with device before manually turning them
on/off.
Inter-connect the Earphones.
• Ensure that earphones are charged.
• Firstly, remove both earphones from the charging case, earphones will turn on and
enter the auto inter pairing mode. After a few seconds both earphones are inter
connected. You will hear a prompt tone when the connection is successful.
• To reactivate inter-pairing mode, simply put the earphones back in charging case and
close the cap, wait few seconds and the follow the above procedure again.
Bluetooth Pairing
After the interconnection is successful, the earphones are ready to pair with your Bluetooth
enabled device.
• Turn on the Bluetooth function on your device and search for "R9 Pro" in the Bluetooth
menu. Select "Kogan H2 Pro Earphones" and you will hear a prompt tone when pairing
is successful.
• Once the connection is successful, you can start using the earphones.
• To disconnect, simply put the earphones back in the charging case and the earphones
will automatically disconnect from any paired devices.
• To reconnect the earphones with same device, simply remove the earphones from
charging case and the earphones will automatically connect to device. (Make sure that
the Bluetooth is turned on the device.) To stop the TWS earphones to auto connect to
any device, delete the earphones from the Bluetooth menu of that device.
Advertisement
