Maintenance - Tunturi E504 Owner's Manual

MAINTENANCE
The Tunturi Recumbent Cycle re¬
quires very little maintenance. Be
sure to clean your cycle with a damp
cloth or towel after each workout.
If you have any problems while
performing maintenance on your cy¬
cle, consult an authorized service
representative.
Replacing the Brake Cable
The brake cable may need to be
replaced after a considerable period
of use.
1. Remove the left pedal.
Use the 15mm open-end wrench
to turn the bolt at the base of the
pedal clockwise to loosen. Gently
pul! the pedal off of the crank.
2. Remove the left cover from the
front frame.
Use a Phillips screwdriver to re¬
move the four (4) Phillips head
screws. Lift off the left cover.
3. Release the brake belt from the
cam clip and unlock it from the
spring.
4. Replace the brake belt.
First, make sure the tension con¬
trol knob on the front frame is
turned counterclockwise to the
lowest setting. Hook the brake
belt onto the spring. Wrap the belt
around the flywheel and attach it
snugly to the cam clip.
5. Replace the left cover and pedal.
Lubricating the Chains
To ensure your cycle will continue
to operate correctly, you will need to
oil the chain once a year.
1
. Remove the right pedal.
Use the 15mm open-end wrench
to turn the bolt at the base of the
pedal counterclockwise to loosen.
Gently pull the pedal off of the
crank.
2. Remove the right cover from the
front frame.
Use a Phillips screwdriver to re¬
move the four (4) Phillips head
screws. Lift off the right cover.
3. Lubricate the chain with a few
drops of household lubricant or
aerosol spray and wipe off any ex¬
cess oil.
4. Turn the pedal to advance the
chain. When the entire chain is
lubricated, reassemble the right
cover.
Changing the Batteries
You will need to replace the batter¬
ies if there is no display in the LCD
window of the electronics module.
To insert or replace batteries, lift
the electronics module from the front
frame. Insert two (2) size AA batter¬
ies into the battery holder. Be sure
the position of the batteries matches
the diagram inside the battery
holder. Replace the electronics mod¬
ule on the front frame.
8