Table of Contents
Advertisement
Available languages
Available languages
a) Fill the tank of the steamer with suitable water (demineralized or
b) Plug the power cord into a power outlet
c)
d) Wait until the device heats up and produces steam, then press
e) When you finish ironing, turn off the device and let it cool down
f)
3.4.
Cleaning and maintenance
a)
Before any cleaning, adjustment, or replacement of accessories, and if the
device is not in use, unplug the mains plug and completely cool down the
device, and get rid of any residual water from both tanks.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
distilled):
Turn on the device with the ON/OFF button:
the steam release button - start with the lowest setting and
possibly increase the amount with the button on the iron or
steamer.
NOTE: The descaling light turns on approximately every 3 months
with regular use.
and unplug it from the power outlet. Empty both water tanks - in
the steamer and in the base of the ironing board.
The device must be completely cooled down before storage.
Advertisement
Table of Contents
