Advertisement
SYSTEM PLANNING CONSIDERATIONS
The L-O8M is a single channel power amplifier so
two units are required for stereophonic operation.
REMOTE POWER SWITCHING
Since they have built-in remote control power swit-
ching circuits, they can be turned on or off with the
power switch of the L-O8C control amplifier. Remote
contro! is also possible with the Kenwood
L-O7C or
L-O7C I control amplifiers.
CONNECTION TO THE L-O8C CONTROL
AMPLIFIER
A 12 meter length © audio cable is supplied with
the L-O8C. Connect it between the OUTPUT 1 connec-
tor of the L-O8C and the INPUT jack of the L-O8M.
Always switch power off before making connections.
PLAN SYSTEM CAREFULLY
Plan the layout of your L-O8M and L-O8C system
carefully to avoid direct exposure
to speaker sound
pressures since vibrations of amplifier components can
affect sound quality. Adverse effects may be slight, but
they can not be overlooked in such a high quality sound
To amplifier SPEAKER
terminals
To © SENSOR (+)
terminal
To (+) terminal
system
as
this,
in which
ultimate
sound
is being
sought.
Keep air space open at the bottom of the unit if a
cushion is placed beneath the L-O8M.
SPEAKER CONNECTING CABLES
Although ordinary speaker cords can be connected
to the SPEAKER terminals, the © (sigma) drive system
will reproduce better sound with the © speaker cable
(supplied) connected to the SPEAKER
terminals.
if the length of the © cable is too short for your
system, commercially available cables as shown in Fig.
1 can be used.
Pay attention to polarities when using such cables.
Keep the cables as short as possible.
For
conventional
speaker
connections,
ordinary
2-core cables can be used.
For those connections, however, see page 4 "' @
SPEAKER terminals"' for full details.
To speaker terminal (+)
or (—)
To (+) terminal
2-core flat cord x 2
To (=) terminal
EZ
To Z SENSOR (—)
terminal
To £ SENSOR
(+)
terminal
To (—} terminal
Twist and solder
as shown.
To (+) terminal
To (+) terminal
To (—) terminal
To (—) terminal
Thick red wire
To L SENSOR
( +}
terminal
EE:
Thin red wire
4-core flat cord
Twist and solder
as shown.
Red wires
To
(+) terminal
To (+) terminal
To
{—) terminal
To (~) terminal
za
To © SENSOR (-)
== :
terminal
~ Thick black wire
~~
Thin black wire
Cable used should include one pair of
red wires (thick and thin) and one pair
Black wires
Twist and so Ider
as shown.
of black wires (thick and thin).
Fig.
1 Substitute Cords for © Speaker Cables
Advertisement
