Circuit Adjustments; 5-1. Electrical Adjustment By Remote Commander - Sony TRINITRON KV-13M10 Service Manual

KV-13M10/MT1300/
RM-Y116 = RM-Y123
KV-14R10/1460R
RM-Y116 _RM-Y123
SECTION 5
CIRCUIT ADJUSTMENTS
5-1. ELECTRICAL ADJUSTMENT BY REMOTE COMMANDER
Use of Remote Commander (RM-Y116/Y123) can be 2. MEMORY WRITE CONFIRMATION METHOD
performed circuit adjustments about this model. 1. After adjustment, pull out the plug from AC
outlet, and next place, plug in AC outlet again.
NOTE: Test Equipment Required. 2. Turn the power switch ON and set to Service
Mode.
3. Call the adjusted items again, confirm they were
1. Pattern Generator
2. Frequency counter
3. Digital multimeter adjusted.
4. Audio OSC
1. METHOD OF SETTING THE SERVICE 3. ADJUST BUTTONS AND INDICATOR
ADJUSTMENT MODE
SERVICE MODE PROCEDURE
1. Standby mode.(Power off)
2, [DISPLAY] —[5]—> [VOL (4)]—> [POWER] on the MY Sony
Remote Commander. (Press each button within a
POWER
second.)
SERVICE ADJUSTMENT MODE IN [4]
Disp Item
(Item) data
SERVICE AFC
0
DISPLAY|
3. The CRT displays the item Being adjusted.
4. Press |1| or [4] on the Remote Commander to select
the item.
5. Press [3] or (6} on the Remote Commander to
change the data.
6. Press |MUTING| then |ENTER| to write into
memory.
SERVICE ADJUSTMENT MODE MEMORY
urine Green
SERVICE WRITE
are Red
7. Press [8| (3| then [ENTER| on the Remote
Commander to initlalize.
Carry out step 7) when adjusting IDs 0 to 4
and when replacing and adjusting IC102.
SERVICE RESET
RM-Y116/Y123
Factory original setting
8. Turn set off and on to exit.