Electrical Hook-Up; Operation - Sears Kenmore HEPA 220 Owner's Manual

AIRINTAKE GRILLE - Dirty airis drawn in360 ° intothe
Kenmore H EPA AirCleaner.
AIROUTLET - Aftertheairhasbeen cleaned b ytheHEPA
filter,itis dispersed U PWARDS intothesurrounding
atmosphere.
CARRYING H ANDLE - Aconvenient handle is provided t o
enable easyrelocation ofyouraircleaner.
FILTER CHANGE D ATE CALENDARS - Two filterchange
datewheels areprovided a sa convenient reminder when
to replace thepre-filter andtheHEPA filter.
SET-UP
Visually inspect the HEPA Air Cleaner upon removing the
unit from its box. Remove and discard any packaging
material. Return the unit if it shows any signs of damage or
mishandling. This unit was .thoroughly inspected and tested
at the factory prior to packaging.
Upon start up of your Kenmore HEPA Air Cleaner, set the
Pre-filter Change Date Calendar ahead 3 months and the
HEPA Change Date Calendar ahead 2 years to indicate
when the next filter replacement is necessary.
CAUTION: DO NOT place the air cleaner within 3 feet of
any computer or any magnetically sensitive devices such
as floppy disks or tapes.
ELECTRICAL HOOK-UP
Plug the air cleaner into a polarized 120 Volt AC wall outlet.
WARNING
To avoid fire or shock hazard, the HEPA Air Cleaner should
only be plugged into a polarized 120 Volt AC outlet.
NEVER operate the HEPA air cleaning system without the
HEPA filter properly installed. Permanent motor damage
could result.
OPERATION
Each time the air cleaner is operated, turn the control
switch to the III (super) position for a fast initialcleaning for
a few seconds. Then adjust the control switch to the
desired output setting:
III (super) - Maximum operation - fast initial cleaning
II (high) - Daytime operation - fast fan speed
I (low) - Night-time - quieter operation
Turn IONIZER switch ON.
CLEANING
WARNING: Prior to any cleaning operation, the air cleaner
must be turned OFF and unplugged from the power
outlet.