Advertisement
Identify the best position where to fix the Octo device:
-
hidden location, where the device cannot be easily seen or found.
-
Presence of a chassis structural part where to fix it, not subject to autonomous vibrations
-
taking care to avoid to fix it on plastic parts of the vehicle (subject to autonomous vibrations) and prefer metallic parts
which are structural and chassis part of the vehicle (since the accelerometer is internal).
-
Pay attention not to shield the GPS antenna side of the device leave at least 10cm from metallic parts.
Find the OBD socket of the vehicle and proceed as follows:
OBD REPLICATOR CABLE
Extension cable:
Insert the Octo OBD device into the free socket at the end of the cable and insert the plug into the OBD port of the vehicle.
Fix the device as indicated below.
OBD Replicator cable:
Remove the vehicle's original OBD socket from its mounting bracket.
Find the correct accessory in the universal kit provided and install it on the "B" socket in order to adapt it to the vehicle's OBD
mounting bracket.
Insert the "B" socket of the cable into the vehicle's OBD port mounting bracket (which is now free).
Insert the "A" plug of the cable into vehicle's original OBD socket and secure it with a plastic tie in an hidden and safe position.
Insert the Octo device into the "C" socket of the cable and fix it as indicated below.
Title: User Manual SmartDiag2GO GD201-O
Rel: 1.1
FIXING OF THE DEVICE
EXTENSION CABLE
Pag. 3 a 5
Advertisement
