Specifications - Kenwood KAC-848 Instruction Manual

problems.
PROBLEM
POSSIBLE CAUSE
No sound.
¢ Input (or output) wires are
(No sound from one side.)
The output level is too
small (or too large).
The sound quality is bad.
(The sound is distorted.)
disconnected.
¢ Protection circuit may be
activated.
SOLUTION
¢ Connect the input (or output)
wires.
the volume was too high.
The input sensitivity adjusting
contro! is not set to the correct
position.
© The speakers wire-are
connected with wrong © / ©
polarity.
screw in the car body.
e The switches may be set
improperly.
fuse and use a lower volume.
Adjust the control correctly
referring to "Controis".
¢ Connect them properly checking
the @ / O of the terminals and
wires well.
¢ Connect the speaker wire again
so that it is not pinched by
anything.
¢ Set switches properly by
referring to "System examples'.
Specifications
Max Power Output (4 Q)
4 Channel Mode ..........ccccccccccccseesececceeeeeescenesenaeeeseereeneneeaaarees 100Wx4
7OWx4
;
3 Channe!
Mode.............:ccccccssecsseeeereeessessneeeees 100Wx2+300Wx1
7OWx2+200Wx1
2 Channel Mode o..0.........cccccceseceeeseeceessseeeeeesneeeesecsnerepesseaeeeea 300Wx2
200Wx2
Rated Power Output (4 Q)
4 Channel Mode (20 Hz ~ 20 kHz, less than 0.08 % THD)....50Wx4
35 Wx4
BOW x2+150Wx1
+
English 117