Table of Contents
Advertisement
CHANGING IDENTIFICATION CODES
Your Identification code has been stored in Menu No. 07
by the Dealer. This code is fixed. However, the Dealer
also stored Identification codes for the stations with
which you will communicate. You can use the
procedure below to change these codes. Acceptable
Group codes can be set by using "x" as a wild card
such
as
"4 Ox",
"0%",
"969
G", or
H>E5465€ a
1, Press [MENU] to enter Menu mode.
2 Press [MODE] or [DATA] to select Menu No. 08, 09,
10, or 11.
3 Enter the first digit by turning the CHANNEL
selector, or by pressing a Microphone [UP] or
[DWN] key.
Press [SCAN] to move to the next digit.
Enter the second digit.
Press [SCAN] to move to the third digit.
Enter the third digit.
Press [MENU] to exit Menu mode.
on
Oa
CHANGING CHARACTER MESSAGES
The Dealer may have programmed the radiotelephone
so that it sends out Character messages instead of the
radiotelephone's Identification code when you
communicate with other stations. The messages
programmed by the Dealer may be changed by you via
Menu mode.
1 Press [MENU] to enter Menu mode.
2 Press [MODE] or [DATA] to select Menu No. 12, 13,
14, or 15.
3 Enter a digit by turning the CHANNEL selector, or by
pressing a Microphone [UP] or [DWN] key.
MENU
al
lek:
/ pss
4 Press [SCAN] to move to the next digit.
5 Repeat Steps 3 and 4 to enter up to 7 digits.
6 Press [MENU] to exit Menu mode.
AUTOMATIC ANTENNA TUNER
PRESETTING (KAT-2 INTERNAL TUNER)
After each successful tuning session, the Preset
function stores the data for the position of the tuning
capacitors. Then, if the channel is changed, the Preset
function automatically positions the capacitors using
data that was previously stored for the new channel.
The first time that a channel is used, the Preset function
uses default data.
KAT-2 INTERNAL TUNER (OPTIONAL)
1 Press [AT TUNE] to start tuning.
*
"TUNE" begins blinking.
TUNE
7
N
40
dB
a
10
s1
3
6b
7
9
20
suseeneeeE
EE
RE
2
4
6
8
*
Pressing [AT TUNE] again cancels tuning.
2 Tuning completes and the Preset data is updated.
*
"TUNE" remains visible on the Display.
+
If tuning does not complete within approximately
20 seconds, five beeps sound over a 10 second
period and the tuning action stops.
KAT-1/ MAT-100 EXTERNAL TUNER (OPTIONAL)
Always switch OFF the power to the radiotelephone
before connecting the KAT-1 or MAT-100 tuner.
1 Press [AT TUNE] to start tuning.
¢
"TUNE" begins blinking.
TUNE
7
N
s1
3s
sb
7
2
a
40 cB
aunweeeee EE
RF
2
4
6
8
10
*
Pressing [AT TUNE] again cancels tuning.
2 Tuning completes.
«
"TUNE" remains visible on the Display.
+
Iftuning does not complete within approximately
20 seconds, five beeps sound over a 10 second
period and the tuning action stops.
Note:
Tuning with the KAT-1 or MAT-100 External Tuner does not
store any Preset data. Therefore, each time that a new channel is
selected, you must retune.
Advertisement
Table of Contents
