Qw: Mog Vssseviccesececsssccsssteassoceudicesesctdvstuessooesvene; Data Operation Istesssscsscessassecvsscsdeceslassebeatvesceedsiees; Pskmode Sisiscdecdssstesnscei Hoe Naneciieeectdaesetecse Dette; Ask. Mode Scscckcvnsceesteavssseedesavadeedvenendectdasddavavestees - Kenwood TRC-80 Instruction Manual

m@ CW Mode
1 Select a CW channel.
2 With a CW key connected to the Rear Panel,
begin sending.
* Closing the key contacts causes the
radiotelephone to automatically switch into
transmit mode, and "TX" appears.
S138 5 7 8 20 40 cB
eueneene ee
RF 2 4 6 8 10
3 Stop sending.
+ The radiotelephone automatically changes
back to the receive mode a moment after you
stop sending, and "TX" disappears.
Note: Adjusting the DELAY control on the Rear Panel allows
you to vary the time that the radiotelephone waits before
returning to receive mode after you stop sending. The same
control allows you to select full break-in (receiver ON
continuously except while key is down).
DATA OPERATION
The [DATA] button must be activated by your
Dealer to function as described here. Also, the
Dealer sets either AFSK or FSK operation, FSK
shift, key-down polarity, high/low tone, and FSK
Reverse functions for your radiotelephone.
FSK MODE
1 Select an FSK channel, then press [DATA].
* "DATA" appears ("USB'/"LSB" disappears).
2 Following the instructions provided with your
Multimode Communications Processor (MCP) or
Terminal Unit (TU), begin sending data.
* "TX" appears each time the radiotelephone
enters transmit mode.
40 dB
a
10
$1 3 5 7 9 20
unseen
RF 2 4 6 8
AFSK MODE
1 Select an AFSK channel, then press [DATA].
¢ "DATA" plus "LSB" or "USB?" is visible.
CH
2 Following the instructions provided with your
Multimode Communications Processor (MCP) or
Terminal Node Controller (TNC), begin sending data.
* "TX" appears each time the radiotelephone
enters transmit mode.
sit 9 5 7 8 20 40 cB
apeeneeee EEE
RF 2 4 6 8 10