Kenwood TH-225A Instruction Manual page 9

@ DOUBLE ROLE KEYS
fis
These 13 keys except the С and keys, have two
functions.
The 1st function is printed on the key.
The 2nd function i s printed above the key.
All these 2nd functions are active for approx. 5 seconds af-
ter pressing the [£] key.
© Numeric keys: Г] - С, 2)
Memory channel 1, 8, and 9 also serve additional functions
as discribed below.
М. channel 1 is used to store the Priority Alert channel
formation.
M. channel B is used to store the lower, and M. channel 9
the upper limit frequency for the programmable band scan.
© UP/DOWN keys: ŒJ , ŒI
These keys are used to increase or decrease the operating
frequency, offset frequency, tone frequency, or the power
saver circuit rate.
© F: Function exchange key
The С key is used to activate the 2nd function.
'The F indicator is displayed for approx. Б seconds after
pressing the Z] key.
СА
You must press the 2nd function while the F indicator is lit, or the
radio will perform the function printed on the key, rather than the
function printed above it.
© M: Memory key
The [€] key is used to select the desired memory
channel.
The operation is similar to that of the [Z] key, in that, the
M indicator will illuminate for 5 seconds in the LCD display
CAUTIOI
The memory channel must be selected within Б seconds of press-
кеу.
© ENTER key
The E key is used to enter a frequency selected by the
numeric keys.
© PRIORITY CHANNEL CHECK key: [Z] then 1/PRIO
These keys are used to monitor whether the priority chan-
nel (CH 1) is busy or not. When this function is activated,
the radio will switch to CH 1 approximately once every 10
seconds.
To cancel this function, press these keys ag: