Model Identification - Sony TA-F110 Service Manual

TA-F110/F210
Harmonic distortion Less than 0.05% at rated output
Intermodulation (IM) distortion (60 Hz:7 kHz = 4:1)
Less than 0.05% at rated output
Frequency response
PHONO: RIAA equalization curve
+0.5 dB
TUNER, CD, VIDEO/AUX, TAPE1,
TAPE2/DAT: 7 Hz — 100 kHz +3 dB
Less than 170 xV (network A)
40 (8 ohms, 1 kHz)
Residual noise
Damping factor
General
System Preamplifier: Low-noise, high-gain
equalizer amplifier
Power amplifier: Pure-complementary
SEPP OCL power amplifier with all
stages directly coupled
Power requirements AEP model: 220 V AC, 50 Hz
UK model: 240 V AC, 50 Hz
E model: 120 V, 220 V or 240 V AC
adjustable, 50/60 Hz
Power consumption AEP model:
TA-F110: 9OW
TA-F210: 150W
UK model:
TA-F110: 160W
TA-F210: 260W
E model:
TA-F110: 7OW
Dimensions Approx. 430 X 135 X 315 mm (w/h/d)
(17 x 53/8 X 12 '/2 inches)
Weight AEP model:
TA-F110: Approx. 5.7 kg (12 Ib 9 oz)
TA-F210: Approx. 7.4 kg (16 Ib 5 oz)
UK model:
TA-F 110: Approx. 5.6 kg (12 !b 6 oz)
TA-F210: Approx. 6.8 kg (15 Ib)
E model:
TA-F110: Approx. 5.6 kg (12 Ib 6 0z)
Design and specifications subject to change without notice.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK A OR DOTTED
LINE WITH MARK A ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL. OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
MODEL IDENTIFICATION
— Specification Label —
SONY:
MODEL NO.
INTEGRATED STEREO AMPLIFIER
WLLL
SERIAL NO.
MADE IN JAPAN
TA-F110
TA-F210
TA-F110:
AEP Model: AC: 220 V ~ 50/60 Hz
UK Model: AC: 240 V ~ 50/60 Hz
E Model: AC: 120, 220, 240 V ~ 50/60 Hz
TA-F210:
AEP Model: AC: 220 V ~ 50/60 Hz
UK Model: AC: 240 V ~ 50/60 Hz
On operating voltage
Before operating the unit, check that the operating voltage of
your unit is identical with the voltage of your local power
supply.
Where purchased Operating voltage
uKmodt ——~«dBOVAAC
AEP model
220 V AC
120 V, 220 V or 240 V AC
adjustable
The voltage selector is located
on the rear panel.
If the selector must be reset,
disconnect the AC power cord
and set the selector to the
proper voltage of your local
power supply.
E model
220 V
240 V
120V