Safety/Precautions .0 - Philips SmartCard PA0113C Instructions For Use Manual

1.
2.
3.
6B.
10.
be read before the appliance is operated.
be retained for future reference.
instructions should be adhered to.
followed.
stand that is recommended by the manufacturer.
"ay, overturn.
cabinet design.
ing amplifiers) that produce heat.
marked on the appliance.
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT
11. Power-Cord Protection - Power supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords and plugs,
eoprenience receptacles, and the point where they exit from the
appliance.
by the manufacturer.
power lines.
Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984,
provides information with respect to proper grounding of the mats
and supporting structure grounding of the lead-in wire to an anten-
na discharge unit, size of grounding connectors, location of antenna-
discharge unit, connection to grounding electrodes and require-
ments for the grounding electrode. See Fig. below.
fall and liquids are not spilled into the enclosure through openings.
qualified service personnel when:
A. The power supply cord or the plug has been damaged; or
B. Objects have fallen, or liquid has been spilled into the appliance;
or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits a
marked change in performance; or
E. The appliance has been dropped, or the enclosure damaged.
beyond that described in the operating instructions. All other servic-
ing should be referred to qualified service personnel.
Note to the CATV system installer: This reminder is provided to call the
CATV system installer's attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building,
as close to the point of cable entry as practical.
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT (nec SECTION 810-20)
GROUNDING CONDUCTORS (NEC section 810-21)
GROUND CLAMPS