Pulse-Eight P8-HDBT-L-SP4 Quick Start Manual

QUICK START GUIDE
neo 1-4 HDBaseT Splitter (P8-HDBT-L-SP4)
This installation guide helps you to install and use your Pulse-Eight neo 1-4 HDBT
Splitter for the first time.
Go to
important technical information not provided in this document and warranty terms
& conditions.
SCAN FOR HELP
CHECK WHAT'S INSIDE THE BOX
• 1 x neo:1-4 HDBaseT Splitter
IMPORTANT!
!
• Please read the instructions before attempting to install or operate this equipment.
• Visit the help.pulse-eight.com
configuration tools.
PANEL DESCRIPTIONS
C
System Health LED: Indicates splitter health.
A
RED - It is powering on or fault found.
GREEN - The system is healthy.
Monitored LED: Indicates the splitter connection to the Pulse-Eight Cloud.
B
RED - It is not connected to the cloud.
GREEN - It is connected to the cloud.
C 48V Power Connector: Use with the supplied power adapter to connect the power.
Ethernet: Connect to network - Required for connection to Web Interface, Third Party Control, and Cloud
D
Remote Monitoring Portal.
HDMI Input: Connect the appropriate high speed HDMI cable to the input. This cable should then be
E
connected to the Source device. (Blu-Ray player etc.)
IR OUT: This port is used to control the connected HDMI Source device (STB, Blu-Ray, etc) using a compliant
F
Pulse-Eight IR Emitter.
HDBaseT Output: Connect the appropriate *Category cable to each output. These cables should then be
G
connected to a neo Receiver at each sink device. (TV/Amplifier etc.).
*Category cable: Cat 5e minimum requirement. Cat 6 or higher category recommended.
help.pulse-eight.com for additional information on this product including
• 1 x Power Supply Adapter
to download the latest product manual, additional documentation, and
D E F
• 1 x Quick Start Guide
A
G
B