Kenwood TM-401A Instruction Manual page 10

Example Bw
LLL
Bracket
slide into the grooves of the mounting bracket.
Flat head Boss Flat
screw washer
Be sure to use flat washers. Otherwise, in-
stallation to the mounting bracket is not done
well. However, when stack installation with
the TM-201A is attempted, do not use these
washers since the stack plates are used.
Fig. c Mounting bracket installation
\) Flat washer
\\ Spring washer
* Hex. head bolt
To install the bracket on a
bent mounting surface, bend
these parts as shown.
10
\\ Flat washer
Tapping screw
Mounting bracket
Mounting surface
Rear part of the
Fig. b Cushion attachment
Affix the cushion (C)
on each side.
Fig. d Transceiver installation
Transceiver installation
Ensure the front/rear of the bracket
when mounting.
Affix the cushion (B).
TM-201A
TM-401A