Troubleshooting - GRE LLEDP56C Installation And Maintenance Manual

Changing the colour (Fig. A)
- Hold the remote control firmly without touching any of the buttons.
- Flick your wrist downwards.
- The change in colour will be displayed on the Central Display.
Changing the sequence (Fig. B)
- Hold the remote control firmly without touching any of the buttons.
- Flick you wrist form side to side.
- The change in sequence will be displayed on the Central Display.
8. CONTROL MOTION MAINTENANCE:
If the Central Display lights up in red without switching off, this means the batteries are low. The battery case is on the
back of the Control Motion unit; replace the old batteries with two new AAA 1.5 V ones.
9. WIRING:
Diagram of the wiring (see page 22)
In order to wire the system properly, a lamp, transformer and the Control Motion unit will be needed.
The transformer should be connected to a 230 V~ac power supply and the lamp (12 V~ac) to the auxiliary winding.
It must be sized to supply the corresponding VA to each LED lamp that is wired (see table on the back cover). For exam-
ple, if you wish to control two 37VA PAR56lamps they must be wired in parallel to the transformer to at least 74 VA.
Alternatively, the system can be controlled using a simple NC push button, in which case there will be 14 function
modes: seven set colours and seven different colour sequences. Each time the push button is pressed, the colour or
sequence will change. By pressing for several seconds, the light becomes white.

10. TROUBLESHOOTING:

Problems
The lamp is not working
The lamp projects a different colour
to that shown on the Control Motion
Central Display
Two lamps project different colours
Using the control motion mode, the
lamp does not work
Control Motion is not responding
11. SAFETY WARNINGS:
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIM-
MING POOLS.
• This lamp is suitable for use in seawater unless projector specifications state otherwise.
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric com-
ponents which have been inserted or handled at locations other than its own premises.
• The PAR56 lamp of LEDs withstands to the treatments of swimming pool described next as long as the values of
concentration do not surpass the following values:
TYPE OF TREATMENT
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
Usual causes
The lamp does not have a power supply
The lamp/s do not receive information
The Control Motion batteries are low
4
Solutions
Connect the lamp to the power supply
through a 12 V~ac safety transformer
1. Get close to the lamp before
sending a command
2. Do not cover the antenna with your
hand
3. Press the REFRESH button
Change the batteries
CONCENTRATION IN WATER
2 g/l
5 g/l
6 g/l