iNels JA3-014M Manual

JA3-014M & JA3-014M/E
Shutter actuator, 14 channels
EN
Characteristics
• JA3-014M is an actuator designed for controlling rollers, shutters, blinds, awnings,
garage doors, entrance gates, etc.
• It controls electric drives that are controlled in two directions and have a built-in
limit switch.
• The unit's status is indicated by the green RUN LED on the front panel
- if the BUS voltage is connected, but there is no communication via
BUS with master, the LED RUN is on continuously.
- if the bus voltage is connected and the unit communicates by BUS,
the LED RUN fl ashes.
• LEDs indication of unit's state on the front panel signals the status of each output.
(only JA3-014M)
• Contact status of each relay can be changed separately and manually by control
buttons on a front panel.
• Software blocking of output relay contacts.
• The unit has synchronized closing and opening of the relay in the zero voltage of
the sinusoidal waveform. The sync inputs are COM 1, 3, 5, 7, 9, 11 and 13 against
the N terminal.
• JA3-014M is normally supplied in the option AgSnO2 contact material.
• JA3-014M in 6-MODULE version is designed for mounting into a switchboard on DIN
rail EN60715.
• JA3-014M/E is an economic option without manual control buttons on the front
panel and status LEDs for the relay output. (possibility to control via iDM software).
Description of device
JA3-014M JA3-014M
1
2 2
3
4
JA3-014M/E JA3-014M/E
1
2
4
1. Data BUS
2. LED inditaction of unit´s state
3. LED output indication
4
4
4. Relay contacts
5. Control buttons
6. Input for phase synchronization
Connection
JA3-014M & JA3-014M/E JA3-014M JA3-014M/E
BUS +
BUS -
L1
L2
L3
M
UP DOWN
N
5
6
6
M M
D O W N UP D O W N U P DOWN
M M M
UP DOWN UP DOWN UP
02-58/2023 Rev.0
M
U P
L1
L2
BUS +
BUS -
DOWN
1/2