Bagging The Clippings - Toro 20384 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it and lock the side-discharge deflector; refer to
the Side-Discharge Chute (page
Installing the Grass Bag
1. Route the starter rope around the lower-rope guide (A of
Note:
The lower-rope guide releases the starter rope when you pull the recoil-start handle.
2. Raise and hold up the rear deflector and unlock the rear plug (B of
3. Pull out the rear plug (C of
4. Hang the upper front edge of the bag from the grass-bag pins on the notches of the handle brackets
(D of Figure 18).
5. Lower the rear deflector.
Removing the Grass Bag
1. Route the starter rope around the lower-rope guide (A of
Note:
The lower-rope guide releases the starter rope when you pull the recoil-start handle.
2. Raise and hold up the rear deflector and lift the grass bag up by the handle off the notches of the handle
brackets (B of Figure
3. Install the rear plug (C of
Important:
Ensure that the rear plug is locked in place. To lock the plug, firmly push the plug in
until it snaps into place behind the tabs, and rotate the lever on the plug to the left (D of
Note:
To unlock the plug, rotate the lever on the plug to the right.
4. Lower the rear deflector.
19).
Figure 18).
19).
Figure 19).
Figure 18).
Figure
Figure 18
Figure 19).
17
Removing
18).
Figure
g231915
19).