Filling With Water - Rowenta GS3010U1 Instructions For Use Manual

Filling with water

Warning ! Never use 100%, distilled
or demineralised water as this can
cause the appliance to spit.
• Your steam brush has been designed to
operate using untreated tap water. If
your water is very hard (check with your
local water authority) it is possible to
mix tap water
distilled or demineralised water in the
following proportions:
-50% untreated tap water,
-50% distilled or demineralised water.
Important: Heat concentrates the
elements contained in water during
evaporation.
• Remove the water tank by pulling it back-
wards - fig.3.
• Remove the stopper.
• Fill the watertank to the M X level with
water - fig.4 and close it securly. Make
sure that the stopper is properly pushed in
place - fig.5.
• Put the tank into the handle until it snaps
in - fig.6.
• Completely unwind the power cord. Plug
in your steam brush - fig.7.
USE
During use or while unit is heating or
cooling, do not rest appliance on its
head. Place product on its side on a
stable, heat resistant, flat surface, as
the head will be hot. s the
appliance heats, the housing
becomes warm. This is normal.
• Once the appliance is plugged in, the light is
on - fig.8.
• fter approximately 50 seconds, and when
the light is off, it has reached working tem-
perature.
• To begin steaming, press by successive
pressures the steam trigger with the steam
brush facing away from you, holding it in
vertical position - fig.9.
with store-bought
Steaming clothes
Before removing or attaching the
fabric brush, unplug your
appliance and let it cool down.
The Ultra Steam is equipped with a fabric
brush.
• To attach the accessory, line it up with the
steam head. It locks into position with an
audible click - fig.2/fig.11a.
• Simply pull on the top of the fabric brush
to remove it - fig.11b. You can operate
the unit with or without the accessory.
• Hang the creased article of clothing on a
clothes hanger
• Pull the clothing tight with one hand. Your
hand must be far enough from the steam
brush to avoid burning it with the steam
output. Place the appliance over the crea-
sed area, beginning at the top of the gar-
ment.
s steam is very hot: never attempt
to remove creases from a garment
while it is being worn, always hang
garments on a clothes hanger.
lways keep your hand far from the
steam output.
• Gently press the fabric brush against the
clothing and move the steam brush down
the fabric. Press by successive pressures,
every 4 seconds, the steam trigger - fig.9.
• The combination of steam and brush will
gently remove the creases.
• fter treatment, let the garment cool down
on the hanger before wearing.
• Remove the fabric brush once unit is un-
plugged and completely cool. Remove it by
pressing on the release tab on top of brush
while pulling it forward.
Lint pad
The lint pad can not be used when
attached to appliance.
Threads, lint and hair can easily be
removed with the lint pad by brushing the
3
EN
FR
ES