Advertisement
Section II
Paragraphs 2-17 to 2-20
Model 415E
©
ADAPTER
FRAME
Figure 2-4.
Two Half Modules in Rack Adapter
a. Connect Model 415E to AC source. Set POWER
switch to CHARGE and charge battery for a minimum
of 16 hours or overnight.
Note: the battery can be
maintained in the charging state indefinitely without
damaging the battery. It will assume its full capacity,
1.25 ampere hour, and no more.
b. Set POWER switch to TEST position, the meter
needle indication should be within the"BAT. CHARGED"
area (see Figure 3-1).
2-17. INSTALLING BATTERY AND INPUT
CONNECTOR.
2-18. Available from Hewlett-Packard are parts re¬
quired for modifying any Model 415E to correspond to
those instruments with Option 01 and/or Option 02. A
rechargeable Battery Installation Kit, hp Part Number
00415-606, contains the battery and necessary hard¬
ware for installation (corresponds to Option 01).
In¬
stallation instructions are detailed in Appendix at rear
of this manual.
To obtain the parts required for an
input connector on the rear panel (corresponding to
Option 02), order by hp Part Number as found in Table
6-1 (listed under Option 02).
Instructions for instal¬
lation of this additional connector are detailed in Ap¬
pendix at rear of this manual.
2-19. REPACKAGING FOR SHIPMENT.
2-20. When returning an instrument to the Hewlett-
Packard Company, use the original packing material
(if foam type) if available or contact an authorized hp
Sales Office for assistance. If this is not possible, first
protect the instrument surfaces by wrapping in heavy
Kraft paper or with sheets of cardboard flat against
the instrument.
Then protect the instrument on all
sides (use approximately 4 inches of packing material
designed specifically for package cushioning), pack in
a durable container, mark container clearly for proper
handling, and insure adequately before shipping.
Note
When an instrument is being returned to the
Hewlett-Packard Company for service or re¬
pair, attach a tag to the instrument specifying
the owner and desired action. All correspon¬
dence should identify the instrument by model
number and the full (eight-digit) serial number.
2-2
02152-1
Advertisement
